Applying Half-Height Wall Panels

HOW TO APPLY YOUR HALF-HEIGHT SCALLOPED PEEL & STICK WALL PANEL

Panel Size: 56cm x 114cm – Can be trimmed to suit your wall height.

You’ll Need:

• Your peel & stick panels

• Level (or laser level)

• Pencil

• Measuring tape

• Scissors or craft knife

• Squeegee or soft cloth
  

Let’s Get Started!

1. Prepare the Surface

• Wipe the wall clean – remove any dust or grease.

• Ensure the surface is smooth and dry.

• Wait at least 4-5 weeks before applying to freshly painted walls.

2. Measure & Plan

• Decide how high you want your panels (typically 90–120cm from the floor).

• Use a level and pencil to gently mark a straight line across the wall.

• Then one plumb line up the wall to get your panels level. (do not line up the egde with a corner as they are often not perfectly level.

• This will be your guide for the top & edge of the scalloped panel.

3. Layout the Panels

• Before peeling, lay out the panels to check alignment.

• Start from one side of the wall and work across.

• If trimming height, do so from the bottom edge so the scallops stay intact.

4. Apply the Panels

• Peel the top edge of the backing and line up with your guidelines.

• Stick the top edge first, then slowly peel and press down the rest of the panel, following your vertical line.

• Smooth from top to bottom using a soft squeegee or soft cloth to remove bubbles.

• Line up the next panel carefully to continue the scallop pattern.

Trimming & Finishing

• Trim around skirting boards or sockets with a sharp blade or scissors.

• Overlap or edge-match corners for a neat finish.

Care Instructions:

• Wipe gently with a soft, dry cloth.

• Avoid harsh cleaning products or scrubbing.

Tip: Take your time with the first panel – once it’s lined up, the rest will flow beautifully!